I uninstalled the LXi VinylExpress software, and re-installed. I had the same problem with my PCut CT1200 vinyl cutter, running through a COM port in Windows 7 fine, then disappeared when I upgraded to Windows 10. Because I searched for DAYS, I will add my comment. Once this is done, restart the computer and check if the issue persists.Click on the ‘compatibility’ tab and check the box ‘Run this program in compatibility mode for’ and select operating system from the drop down menu and proceed with the installation.Right-click on the setup.exe file and click on ‘properties’.Find the application installer file location.Follow these steps to install the drivers in compatibility mode and check if that helps. Compatibility mode runs the program using settings from a previous version of Windows. Install the application in compatibility mode. This issue might have caused due to incompatibility issue. For Mac can take a set of individual creation pcut ct 630 driver located on your machine or discoverable through Web sites and combine them into shapes that can then be saved and shared. I suggest you to install the Application in Compatibility mode and check if it helps.įor any one thats lloking for the driver and manual for the Creation PCUT CTO630 here they are: Creation PCUT CTO630 Manual. Hi, I realize that the application is not running in Windows 10.